HZ Z Anchors – Overview

View HZ Z Medium Load Anchor Products

HZ

 

  • Direct fixing into concrete walls with expansion bolts. Indirect fixing into sub channel system with hex bolts.
  • Three dimensional adjustability – Quick and easy fixing.
  • Installation at horizontal and vertical joints.
  • Recommended projection sizes up to 5-5/16″ (135 mm) & loads up to 180 lbf (800 N).
HZ Z Anchor Fixing Systems - Three dimensional adjustability 1
HZ Z Anchor Fixing Systems - Three dimensional adjustability 2
HZ Z Anchor Fixing Systems - Three dimensional adjustability 3
1) Vertica adjustment is provided by the slotted hole. The anchor is fixed onto the bolt with the serrated washer at the desired level.
2) Adjustment of the projection size is provided by rotating the adjustable arm. The adjustable arm is locked with the hexagon nut.
3) Adjustment of the anchor left and right is provided by sliding the body up to 15 degrees side ways.

Installation at horizontal joints

HZ Z Anchor Fixing Systems - Installation at vertical joints

Installation at vertical joints

HZ Z Anchor Fixing Systems - Installation at horizontal joints

  • Suitable for wood framing and concrete walls. Anchors are fixed directly onto wood or concrete substrate with expansion bolts.
  • Recommended projection size between 1-3/4″ – 5-5/16″ (45 – 135 mm) and loads up to 180 lbf (800 N).
  • In horizontal joint installation, slabs are pinned on the bottom and upper sides. Anchors act as load bearing carrying half the weight of the slabs above. Anchors also act as restraints, holding the slabs below and restraining against wind suction and pressure.
  • In vertical joint installation, slabs are pinned on the left and right sides. Anchors on the bottom are load-bearing anchors carrying the whole weight of the slab. Half the weight of the slab on the left and half the weight of the slab on the right. Anchors on the top are restraint anchors holding the slabs and restraining against wind suction and pressure.
  • Three – dimensional adjustability allows quick and easy installation. Plenty of flexibility.
  • The design and structural calculations of these anchors are made in our technical department or through a structural engineer of your selection. Special design and manufacturing can be made for the requirements of each project.

HZ Z Anchor Fixing Systems – Installation

HZ Z Anchor Fixing Systems - Installation 1
HZ Z Anchor Fixing Systems - Asjustable Arm Variations
HZ Z Anchor Fixing Systems - Installation 2
1- Through bolt
2- Anchor body
3- Serrated washer
4- Round washer
5- Hex nut for through bolt
6- Hex nut for adjustable arm
7- Adjustable arm
8- Plastic tube
9- Flanged pin

Installation at horizontal joints

HZ Z Anchor Fixing Systems - Instalation of horizontal joints 1

Installation at vertical joints

HZ Z Anchor Fixing Systems - Instalation of vertical joints 1

In this instance the dead load of the slab is divided by two, as half the weight of the slab is transferred to the load bearing anchors.
In this instance the dead load is divided by one, as the whole weight of the slab is transferred to the load bearing anchors.

Installation at horizontal joints

HZ Z Anchor Fixing Systems - Installation at horizontal joints - HZ02 Z Anchor
HZ Z Anchor Fixing Systems - Instalation of horizontal joints 3
HZ Z Anchor Fixing Systems - Instalation of horizontal joints 2

Installation at vertical joints

HZ Z Anchor Fixing Systems - Installation at vertical joints - HZ02 Z Anchor
HZ Z Anchor Fixing Systems - Installation at vertical joints - HRS01 Restraint Anchor
HZ Z Anchor Fixing Systems - Instalation of vertical joints 2
HZ Z Anchor Fixing Systems - Instalation of vertical joints 3